FCC Compliance
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1)this device may not cause harmful interference, and
(2)this device must accept any interference received, including interference that may cause undesired operation.
NOTICE:
Changes or modifications made to this equipment not expressly approved by Datalogic S.r.l. may void the FCC authorization
to operate this equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 18 of the FCC Rules. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Increase the separation between the equipment and any other radio device.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
ISED Compliance
NOTICE:
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1)this device may not cause harmful interference, and
(2)this device must accept any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Radiofrequency Radiation Exposure Information
This device was tested for E and H field to demonstrate compliance with RF exposure limits, according to international
Standards covering human exposure to electromagnetic fields from radio devices.
More information about the relevant Standards for RF exposure measurement methods and procedures may be found in
the CE DoC included in the product user manual available at
website and at the FCC public listing
under the FCC IDs specified in the FCC/IC labeling section.
This device is compliant with RF exposure limits for general population/uncontrolled exposure specified in Council
Recommendation 1999/519/EC Annex II.
Radio Technologies and Frequency Bands
The JOYA TOUCH Single Slot Dock Locking incorporates the following radio technologies and supports the corresponding
frequencies, as specified below:
Radio Technology
Frequency Bands
NFC (Near Field Communication)
13.56MHz
Wireless Charging (Transmitter)
130kHz
NOTES
