24
2. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
3. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired ope
ration.
4. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
y
Reorient or relocate the receiving antenna.
y
Increase the separation between the equipment and receiver.
y
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
y
Consult the dealer or an experienced radio/TV technician for help.
IC Specific Certification Compliance
Under the regulations of the IC the user has to be aware of the following when using the Datalogic HandScanner:
1. This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two condi-
tions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of
the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes:
1) l’appareil ne doit pas produire de brouillage;
2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
LASER CLASS 2 (mid range):
Complies with 21CFR1040.10 and 1040.11 except for deviations pursuant to Laser Notice No. 56, dated June 24, 2007.
Laser safety according to EN60825-1:2014 and IEC 60825-1 (Ed. 3.0).
The laser warning label is
located on the bottom of
HandScanner (mid range)
DIRECTIVES & CERTIFICATION
European Directives
2014/53/EU Radio Equipment Directive (RED)
2011/65/EU Restriction of Hazardous Substances (RoHS)
2015/863/EU
Declaration of Conformity
Datalogic S.r.l. hereby declares that the devices are in compliance with all applicable Directives. For the full text of the
CE Declaration of Conformity please contact the Datalogic Support (
).
FCC/IC Certification Compliance
The Datalogic HandScanner System comprised of: HandScanner MR, HandScannr SR, Datalogic Charging Station, Data-
logic Gateway, wearables, peripherals and accessories, complies with the following FCC/IC product categories:
y
FCC Part 15 Subpart C 247 (intentional radiators = RF transceiver)
y
FCC Part 15 Subpart C 249 (intentional radiators = RF transceiver)
y
FCC Part 15 Subpart B 107/109 (unintentional radiator)
y
ISED Canada RSS-Gen Category I (radio apparatus)
y
ISED Canada RSS-247
y
ISED Canada RSS-102
y
ISED Canada RSS-210
The Datalogic HandScanner is a portable device (distance between person’s body and theantenna is 20 cm or less) and
excluded from SAR (Specific Absorption Rate) requirements.
Under the regulations of the FCC and the IC the user has to be aware of the following when using the Datalogic Hand-
Scanner:
1. This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets
the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules. This
equipment has very low levels of RF energy that are deemed to comply without testing of specific absorption rate (SAR).
Cet équipement est conforme aux limites d’exposition aux rayonnements énoncées pour un environnement non contrôlé
et respecte les règles d’exposition aux fréquences radioélectriques (RF) des lignes directrices de la FCC et les règles
d’exposition aux fréquences radioélectriques (RF) CNR-102 de l’IC. Cet équipement émet une énergie RF très faible qui
est considérée comme conforme sans évaluation du débit d’absorption spécifique (DAS).
2. This HandScanner system has been tested and meets the FCC/IC RF exposure rules when used with Datalogic acces-
sories supplied or designated for this product. Use of other accessories may not ensure compliance with FCC/IC RF
exposure rules.
Le système Datalogic a été testé et est conforme aux règles d’exposition aux fréquences radioélectriques (RF) de l’IC
ainsi que de la FCC lorsqu’il est utilisé avec les accessoires Datalogic fournis ou conçus pour ce produit. L’usage d’autres
accessoires ne garantit pas nécessairement la conformité aux règles d’exposition aux RF de l’IC ou de la FCC.
FCC Specific Certification Compliance
Under the regulations of the FCC the user has to be aware of the following when using the Datalogic HandScanner:
1. FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s autho-
rity to operate the equipment.
