Datalogic Gryphon I GD44XX, Product Reference Manual

Page: 25 / 324

Configuring the Base Station
Product Reference Guide 23
Figure 11. Disconnecting the Cable
Insert
Paper Clip
Connecting the Base when Security Pin is Enabled
When connecting the Base to a system that has a custom Security Pin enabled, follow the steps
below in the order shown:
1. Power down the host system.
2. Connect the appropriate interface cable into the Base as shown in Figure 10 .
3. Place the reader in the Base.
4. Power up the host. The reader will link to the Base
5. When the host completely powers up, a new custom Security Pin Code may be sent to the
reader and Base, depending on host configuration. Contact Datalogic Technical Support
for more information.
If you want to change security settings or set up a PIN, see
"BT Security
Mode" starting on page 241
.