Datalogic Gryphon I GD44XX, Product Reference Manual

Page: 242 / 324

Enter/Exit Programming Mode
238 Gryphon™ I GD44XX / GBT4400
ACK TIMEOUT
This option designates wait time in 200-millisecond ticks for an ACK of a transmitted packet
(Tack). The selectable timeout range is 200 to 51,000 milliseconds (01-0xFF) in 200
millisecond increments. A setting of 00 causes the system to wait forever.
See page 252 for more information on setting this feature.
$CBTAT
Set ACK Timeout
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE barcode above, then the barcode at
left followed by the digits from the Alphanumeric char-
acters in
Appendix D, Keypad
representing your
desired character(s). End by scanning the ENTER/EXIT
barcode again.
Make a mistake? Scan the CANCEL bar code to
abort and not save the entry string. You can then
start again at the beginning.
~
CANCEL
DEFAULT
00 ACK Timeout value is “Wait Forever”
RF ADDRESS STAMPING
These features allow configuration of source radio data inclusion.
Source Radio Address Transmission
Enables/disables the ability of source radio address information to be transmitted to the host
and, if so, at what position with respect to the label data. See
page 279 in “References” for
detailed information and examples for setting this feature.
DEFAULT
$CBTAS00(CR)
Source Radio Address Transmission = Do Not Include
$CBTAS01(CR)
Source Radio Address Transmission = Prefix
When included as a prefix, the source-radio ID is displayed after all label
formatting has been applied. The 6 byte hex address is sent as 12 ascii char-
acters, i.e., an address of 00 06 66 00 1A ED will be sent as (shown in hex):
30 30 30 36 36 36 30 30 31 41 45 44