Selecting the Interface Type
8
Gryphon™ I GD44XX
Selecting the Interface Type
Upon completing the physical connection between the reader
and its host, proceed directly to Interface Selection below for
information and programming for the interface type the read-
er is connected to (for example: RS-232, Keyboard Wedge,
USB, etc.) and scan the appropriate bar code to select your sys-
tem’s correct interface type.
Interface Selection
Each reader model will support one of the following sets of
host interfaces:
General Purpose Models:
RS-232, RS-232 OPOS, USB, Key-
board Wedge, Wand.
Retail Point of Sale Models :
RS-232, RS-232 OPOS, USB,
IBM 46XX.
Information and programming options for each interface type
are provided in this section. For defaults and additional infor-
mation associated with each interface, proceed to the corre-
sponding chapter in the Gryphon™ 4400 PRG.
Configuring the Interface
Scan the appropriate programming bar code to selects the in-
terface type for your system.
Unlike some other programming features and
options, interface selections require that you scan
only one programming bar code label. DO NOT scan
an ENTER/EXIT bar code prior to scanning an inter-
face selection bar code.
Some interfaces require the scanner to start in the
disabled state when powered up. If additional scan-
ner configuration is desired while in this state, pull
the trigger and hold for 5 seconds. The scanner will
change to a state that allows programming with bar
codes.
Summary of Contents for Gryphon I GD44 Series
Page 5: ...NOTES...
