Datalogic GBT4400BK, Product Reference Manual

Page: 115 / 350

Enter/Exit Programming Mode
Product Reference Guide 105
Stand Mode Illumination Off Time
Specifies the amount of time reader illumination stays off after pulling the
trigger when in Stand Mode. The configurable range is 01 to 32 by 01 in
increments of 500ms (500ms to 16 seconds). See page 295 in “References”
for a description of this feature.
$CSNTM
Select Stand Mode Time Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad
representing
your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Scanning Active Time
This setting specifies the amount of time that the reader stays in scan ON
state once the state is entered. The range for this setting is from 1 to 255
seconds in 1-second increments. See page 296 in “References” for further
description of this feature.
Scanning Active Time = 3 seconds
Scanning Active Time = 5 seconds
Scanning Active Time = 8 seconds
DEFAULT
04 = 2 Seconds
$CSNET03(CR)
$CSNET05(CR)
DEFAULT
$CSNET08(CR)