Datalogic DX8200, Reference Manual

Page: 50 / 56

DX8200 CONTROLLER
38
5
NOTE
ASR
works only if the Slave devices have software 1.30 and later for 6000
Family scanners.
5.3 REPLACING THE PROTECTION FUSES (FOR AC MODELS)
WARNING
The device must be opened by qualified personnel only.
WARNING
Before removing the fuses from DX8200 Controller, make sure the power
supply cable is disconnected to avoid shock or harm to the operator.
Two protection fuses are located next to the on/off switch (Figure B, 12).
To replace them, turn the device off and disconnect the power supply cable; then, with a
screwdriver remove the fuses and replace them with new ones of the correct value (see the
following fuse selection table).
Connect the power supply cable and turn the device on again to verify the success of the
operation.
Version Fuse Type
85 - 264 Vac 3.15 A F