DS6300 REFERENCE MANUAL
6
1
1.5 INDICATORS
The DS6300 has three LEDs on the Display and Keypad panel. The indicators have the
following functions:
POWER ON
(red)
Indicates the scanner is turned on.
PHASE ON
(yellow) Indicates the external presence sensor is active.
TX DATA
(green) Indicates data transmission on the main serial interface.
1.6 KEYPAD AND DISPLAY
The DS6300 keypad allows entering a menu for selection of one of the following functions:
Welcome:
shows the current software release and operating mode;
Autolearn:
starts the procedure making it possible to obtain an automatic, accurate
and fast configuration of DS6300 without the necessity of directly
checking/modifying the relevant parameters;
Internal Net:
defines scanner function within the local Lonworks network (see below);
Ethernet Mode: allows setting the scanner IP address of the Master scanner to be used
within the Host network;
LCD Contrast: sets the LCD contrast;
Bus:
allows setting the scanner address (value range 0-125) to be used in a
Profibus network;
Test Mode:
allows verifying the scanner reading position and features (see below).
The same settings may be performed by using the Genius™ program (see chapter 8 for
details).
1.6.1 Internal
Net
This submenu can be used as an alternative to configuration through Genius™, to assign the
DS6300 scanner within a local Lonworks master/slave network.
It allows defining the scanner function (slave/master) within the Lonworks network and, if
configured as Slave, its address.
To enter the Internal Net submenu and configure the scanner follow the given procedure:
1) Press and hold both the
▲
(up arrow) and
▼
(down arrow) keys for about 2 seconds to
enter the Main menu;
2) Use the
▲
(up arrow) or
▼
(down arrow) key to select the “Internal Net” item, then press
the ENT (enter) key to confirm;
3) Use the
▲
(up arrow) or
▼
(down arrow) key to select the “LonWAddrSel”” item, then
press the ENT (enter) key to confirm;
4) Use the
▲
(up arrow) or
▼
(down arrow) key to select your scanner function among
“Master”, “Slave n”, “Slave jolly”, “Disabled”; then, press the ENT (enter) key to confirm;