HF-CNTL-PBS- 0 2 I N S T A L L A T I O N G U I D E – R E V . 0 3 P A G E 1 4 O F 2 3
2.3
I
NS TA L LI NG TH E
HF-CNTL-PBS-02
Note: review Section 2.1.2: “Installation Guidelines” prior to installing the
controller.
1. Attach the Cobalt HF Antenna to the Cobalt HF Controller as per the
instructions in Section 2.2: “Connecting the Antenna.”
2. Select a suitable location for the Cobalt HF Controller/Antenna. If
necessary, fabricate mounting brackets from durable plastic.
3. Fasten combined controller and antenna to your mounting fixture using two
M5 (#10) diameter screws (not included). Pass screws through antenna’s
mounting holes and secure them with appropriate washers and nuts.
Tighten screws to 1.7 Nm or 15 lbs per inch ± 10%.
4. Connect the three wires from your power supply to pins 1-3 on the 5-pin,
female, M12 connector (P/N: CBL-1487 included).
5. Attach the
CBL-1487
connector to the 5-pin, male, M12 connector on the
Cobalt Controller.
6. Attach a Profibus-compatible data cable (
P/N: CBL-1438-XX not included)
to the 5-pin, male M12 interface connector on the Cobalt. Connect the other
end of this cable to your Profibus network.
7. Turn your power supply ON. The green
PWR (power) LED
on the Cobalt will
illuminate. After the boot process is complete, The two “Profibus
” LEDs
on
the controller may appear green or off depending on the status of the
connection with your Profibus network.
OPTIONAL STEPS FOR ADDITIONAL CONFIGURATION
Steps 9 through 11 below are considered optional and only need to be
completed by users that wish to modify their Cobalt controller’s internal
configuration.
8. To modify the controller’s internal configuration, connect an 8-pin, RS232-
compatible, serial interface cable to the 8-pin, male M12 interface connector
on the Cobalt. Connect the other end of this cable to a COM port on your
host computer.
9. On the host computer, set COM port parameters to the following values:
