4-11/16”
Installation Instructions 50-3321-WH-KIT (continued):
Final Instructions for New & Retrofit Installation:
1.
Once you have wired the receptacle, begin by inserting the
receptacle portion of the plate into the electrical work box. When
the entire RCP with Recessed Power Outlet is flush to the wall,
using the two white screws supplied, screw the receptacle
portion of the plate to the work box. Next, screw down the
screws with wings. These wings will fasten tightly against the
back of the drywall.
2.
Now that the RCP with Recessed Power Outlet is installed,
install the low voltage mounting bracket directly below the RCP
with Recessed Power Outlet and parallel to the existing electrical
outlets. Run the A/V cables through the recessed portion of the
RCP with Recessed Power and fish the A/V cables through the
wall and then pull the A/V wires through the opening in the low
voltage mount bracket. Now pull the A/V wires through the
recessed opening in the recessed cable plate. Insert the
recessed cable plate into the installed low voltage mounting
bracket and secure it to the wall with the included screws.
Connect you’re a/V cables to your equipment.
3.
Remember to switch the appropriate circuit breaker ON.
4.
Now install your flat panel TV mounting bracket per the flat panel
TV bracket manufacturer’s instructions.
5.
Make sure to read all instructions.
WARNING
DataComm Electronics’ products shall be installed and
used only as indicated in DataComm Electronics’ product
instruction sheets.
Instruction sheets are available online at
www.datacommcableorganizer.com.
CAUTION
For shock protection, this device must be properly
grounded.
Use copper wire only with this device.
IMPORTANT INSTRUCTIONS
Read and understand all instructions.
Follow all warning and instructions marked on the product.
Do not use this product near water, for example near a bath
tub, wash bowl, kitchen sink, or laundry tub, in a wet
basement, or near a swimming pool.
SAVE THESE INSTRUCTIONS.
TEMPLATE
Recessed Cable Plate
with Recessed Power Outlet
ACTUAL SIZE
ONLY LICENSED PROFESSIONALS SHOULD INSTALL THIS PRODUCT
This product is patent protected by U.S. Patent numbers D553475, D554475 and 7390964
Multiple patents pending
RoHS Compliant
CUT ALONG DOTTED LINE
3-3/4”
Figure 3
Page 2 of 3
3/23/10 Rev. 5