Instruction/Installation Sheet for In-Wall Power Extension Kits (6623)
DataComm Electronics
6349 Peachtree St.
Norcross, GA 30071-1725
888.223.7977
www.datacommelectronics.com
Parts Included:
1.
Pre-Assembled Top Plate w/ 15A / 125V duplex
receptacle/ female connector
2.
Pre-Assembled Bottom Plate w/ female connector
3.
In-Wall Power Cord w/ two male connectors &
strain relief
4. 3
ft. extension cord w/
360
º
rotating flat head
Tools Needed:
1.
Drywall Saw
2.
6 ft. Tape Measure
3.
Pencil
4.
Phillips Head Screwdriver
IMPORTANT INSTRUCTIONS:
• Always follow local electrical code when installing this product.
• The electrical parts in this kit are designed to be used only as a kit and none of these electrical parts are designed to be used
individually.
• This product is not designed to be part of your home or a commercial building’s electrical wiring system.
• This installation is only energized (electrically active) when the supplied 6 ft. cord is plugged into the recessed straight blade
inlet (located on the recessed low voltage cable plate) and the straight blade end of the 6 ft. cord is plugged into either your
surge protector or wall receptacle.
• This product is designed for retrofit work only because the electrical outlet box cannot be attached to a stud.
If you are not familiar with home wiring systems, please call a qualified electrician to install this product.
WARNING:
• DataComm Electronics’ products shall be installed and used only as indicated in DataComm Electronics’ product instruction sheets.
• Instruction sheets are available online at www.datacommelectronics.com
CAUTION:
• For shock protection, this device must be properly grounded.
• Use copper wire only with this device.
IMPORTANT INSTRUCTIONS:
• Read and understand all instructions.
• Follow all warnings and instructions marked on the product.
• Do not use this product near water, for example; near a bathtub, wash bowl, kitchen sink, laundry tub, in a wet basement, or near a swimming
pool.
• SAVE THESE INSTRUCTIONS
Page 1 of 3
11/05/2018
