Installation / Instruction Sheet 45-0041-WH (Continued)
1. The green light emitting diode (LED) is “on” when power is “on” and surge protection
is present.
2. The green LED will “flash” when surge protection has been lost.
3. The green LED will be “off” when power to the receptacle is “off”.
4. In units equipped with an audible alarm, the alarm will sound continuously if surge
protection is lost. The alarm may be silenced by turning the “ALARM OFF” screw on
front of the receptacle clockwise.
5. This device features an internal protection that will disconnect the surge protective
component at the end of its useful life but will maintain power to the load - now
unprotected.
WARNING
DataComm Electronics’ products shall be installed and used only as indicated in DataComm Electronics’ product instruction
sheets.
Instruction sheets are available online at www.datacommelectronics.com.
CAUTION
For shock protection, this device must be properly grounded.
Use copper wire only with this device.
IMPORTANT INSTRUCTIONS
Read and understand all instructions.
Follow all warnings and instructions marked on the product.
Do not use this product near water, for example near a bath tub, wash bowl, kitchen sink, laundry tub, in a wet basement, or near
a swimming pool.
SAVE THESE INSTRUCTIONS.
Surge Suppressor Specifications
ONLY LICENSED PROFESSIONALS SHOULD INSTALL THIS PRODUCT
888.223.7977
www.datacommelectronics.com
REV. 11/12/2019
Page 2 of 3
Inside the Hubbell Surge Protection Receptacles are two 22mm square MOV’s providing 240 joules /15000A of surge protection for each mode. Meets UL
Standards 1449 3rd Edition and 498: CSA Certified. Damage-alert alarm sounds when surge protection is no longer functioning and keeps sounding until
the muting screw is utilized or the receptacle is replaced. Power-on indicator light verifies instantly that power is available at the receptacle and the
suppression circuit is fully functional; light off means power has been interrupted, flashing light indicates surge protections circuitry has been damaged.
Replacement surge suppressor can be purchased from DataComm Electronics or an authorized Hubbell Wiring Device distributor.
