SD260L/SD360/SD460 Installation and Administrator’s Guide
A-5
Bolt-Down Option
The laminator includes bolt-down openings that you can use to secure the system to a mounting
surface.
You need the following supplies:
The bolt-down kit (part no. 509169-001) contains two M6 well nuts.
Two M6 (6 mm) screws, purchased separately.
The length of the screws you need depends on the thickness of the mounting surface. The
screw length is the surface thi 0.75 inch (20 mm).
Two M6 washers, purchased separately.
1/4-inch (7 mm) drill bit.
1.
Drill two holes in the mounting surface following the dimensions and requirements shown in
the following figure:
This procedure is optional.
Summary of Contents for SD260L
Page 8: ...viii ...
Page 30: ...18 Installation ...
Page 48: ...36 Elements of Card Design ...
Page 114: ...102 Supplies and Parts ...