DataCard Datacard SP35, Installation Manual

Page: 8 / 199

7
SP Series Install e-Guide
Unpacking and connecting the printer
This section includes:
• "Unpacking the printer"
• "Powering on an SP35 or SP55 printer"
• "Powering on an SP75 printer"
• "Data cables"
• "Is the printer ready for driver installation?"
Unpacking the printer
The printer is compact and easy to unpack.
1 Open the shipping carton.
2 Remove the installation map. The top side shows the accessories shipped with the printer. If the printer
includes optional items, the options are checked on the installation map.
3 The cables, Printer Guide, and other supplies are contained in the accessories tray. For SP35, lift out the
accessories tray.
4 The printer is located between two shipping supports. Lift off the top shipping support and put it aside.
5 Lift out the printer and place it on a work surface.
6 For SP55 printers, remove the tape at the back of the printer that holds the duplex door closed.
7 For SP75 printers and SP55 printers with the Built-in Ethernet feature, attach the guide holder to the side of the
printer and insert the
SP Series Network Printer Guide .
8 After unpacking the printer, put the shipping carton, shipping supports, and accessories tray aside in case you
need to ship the printer in the future.
If any items are missing, contact your dealer or reseller to inform them.
Powering on an SP35 or SP55 printer
For best results, load supplies before powering on the printer.
1 Plug the power supply cord into the printer (1). The power receptacle is located on the side of the printer.
2 Plug the power cord into the power supply (2).
3 Plug the other end of the power cord into a single-phase, 3-wire grounded receptacle with 90-130V AC or 195-
254V AC at 50 or 60 Hz (3).
The printer power supply automatically adjusts to the voltage of the input power.
Powering on an SP75 printer
For best results, load supplies before powering on the printer.
1 Plug the power cord into the printer (1).