DataCard CR805, Installation And Administrator'S Manual

Page: 139 / 152

CR805 Retransfer Card Printer Instrallation and Administrator’s Guide A-7
Secure the Laminator
You can secure the laminator using one of the following:

The bolt-down openings in the bottom of the laminator enclosure

An optional cable lock
Use the Bolt-Down Openings
The laminator includes bolt-down openings that you can use to secure the system to a mounting
surface.
You need the following supplies:

The bolt-down kit (part no. 509169-001) contains two M6 well nuts.

Two M6 (6 mm) screws, purchased separately.
The length of the screws you need depends on the thickness of the mounting surface. The
screw length is the surface thi 0.75 inch (20 mm).

Two M6 washers, purchased separately.

1/4-inch (7 mm) drill bit.
This procedure is optional.