Data Translation MACH Series, Getting Started Manual

Page: 33 / 62

Connecting Signals
25
4
4
4
4
4
4
4
4
4
Connecting Video Signals
To connect signals to connector J1 on the DT3154 board, perform the
following steps:
1. After making sure power to the computer is off, push the 15-pin
connector of the EP306 cable into the J1 socket at the rear of the
DT3154, as shown in
Figure 3 , and tighten the screws on the
connector.
Figure 3: Connecting the EP306 Cable to Connector J1
2. Attach EP306 connector 0 (RVID0) to the video input source’s
Red Video Out jack or to a monochrome input.
Note: The EP306 attaches to female BNC connectors. If the video
out connector on your video input source is a male BNC or an
RCA connector, you need to obtain the appropriate adaptor
(available at electronic equipment stores).
J1
RVID0 - 0
GVID0 - 1
BVID0 - 2
RVID1 - 3
GVID1- 4
BVID1 - 5
EXT_SYNC - 6
EXT_TRIG - 7
EP306
D_OUT0 - 8
D_OUT1 - 9
D_OUT2 - 10
D_IN0 - 11
D_IN1 -12
COMP_SYNC - 13