Data Translation MACH Series, Getting Started Manual

Page: 13 / 62

Overview
5
1
1
1
1
1
1
1
1
1
Getting Started Procedure
The flow diagram shown in Figure 1 illustrates the steps needed to
get started using the DT3154 board. This diagram is repeated in each
chapter; the shaded area in the diagram shows you where you are in
the getting started procedure.
Figure 1: Getting Started Flow Diagram
Install the Board
(see Chapter 3 starting on page 17 )
Connect Signals to the Board
(see Chapter 4 starting on page 23 )
Verify Board Operation
(see Chapter 6 starting on page 45 )
Install and Configure the Device Driver
(see Chapter 5 starting on page 29 )
Prepare to Use the DT3154 Board
(see
Chapter 2 starting on page 7 )