Data Translation DT9820 Series, Getting Started Manual

Page: 46 / 76

Chapter 6
38
−
Then, run the Quick Data Acq application (described in
Chapter 7 starting on page 49 ) to verify that the function
module is operating properly.
Once you have determined that the function module is
operating properly, wire the signals according to your
application’s requirements.
Note:
Connector J1 is tied to the host computer’s chassis
ground.
Table 6 lists the assignments of the screw terminals on the STP9820
screw terminal panel.
Table 6: Screw Terminal Assignments of the STP9820
Screw Terminal Panel
Screw Terminal
Block
Terminal
Number
Terminal
Label Signal Description
TB1 1 CH0H Analog Input Subsystem 0 High
2 CH0L Analog Input Subsystem 0 Low
3 AGND Analog Ground
4 CH1H Analog Input Subsystem 1 High
5 CH1L Analog Input Subsystem 1 Low
6 AGND Analog Ground