Data Translation DT3162, User Manual

Page: 51 / 80

Connector Pin Assignments
41
B
B
B
B
B
B
B
B
B
.
The VIDEO 1, female BNC connector provides access to the video
input 1 signal. The VIDEO 2, female BNC connector provides access
to the video input 2 signal.
Table 13: Hirose (CAMERA) Connector Pin Assignments
Pin Description Pin Description
1 Digital Ground 2 +12 V
a
a. This is the input from the 12 VDC terminal block.
3 Video 0 Return 4 Video 0
5 Digital Ground 6 HSync or Expose/ Reset
b
b. To access the HSync signal on pin 6, install jumper W3 (by default, this jumper is
installed); or to access the Expose/Reset signal on pin 6, install jumper W2.
7 VSync or Expose/Reset
c
c. To access the VSync signal on pin 7, install jumper W11 (by default, this jumper is
installed); or to access the Expose/Reset signal on pin 7, install jumper W10.
8 Digital Ground
9 HSync, Pixel Clock, or
Expose/Reset
d
d. To access the HSync signal on pin 9, install jumper W5; to access the Pixel Clock signal
on pin 9, install jumper W6; or to access the Expose/Reset signal on pin 9, install jumper
W4 (by default, this jumper is installed).
10 Digital Ground
e
e. To access the Digital Ground signal on pin 10, install jumper W1 (by default, this jumper
is installed). If jumper W1 is not installed, this pin is not connected to any signal.
11 Pixel Clock,
Expose/Reset, or +12 V
a,f
f. To access the Pixel Clock signal on pin 11, install jumper W9; to access the Expose/Reset
signal on pin 11, install jumper W7; or to access the+12 V signal on pin 11, install jumper
W8 and connect the +12 V signal to Solder Pad 1 (SP1).
12 Digital Ground