Data Translation DT3157, Getting Started Manual

Page: 39 / 68

Connecting Signals
31
4
4
4
4
4
4
4
4
4
Using the EP-301 Cable (Pulnix Cameras)
The EP-301 cable is for use with Pulnix and similar digital cameras.
The cable provides connection between the DT3157 and the camera’s
31-pin, D-shell connector. Also provided is a BNC connector at the
camera end for connecting an external trigger. The cable is illustrated
in
Figure 5 .
Figure 5: EP-301 Cable
To connect your digital camera to the DT3157 board, perform the
following steps:
1. Push the 68-pin connector of the EP-301 cable into the J1 socket at
the rear of the DT3157 board and tighten the retaining screws.
2. Attach the 31-pin connector of the EP-301 cable to the camera.
3. If you are using an external trigger, connect the BNC connector to
the digital output signal from your camera.
The signals brought out by the connectors on the EP-301 cable are
defined in
Table 4 .
BNC
31-pin
Camera DT3157
68-pin
(J1)