Data Translation DT3145, Getting Started Manual

Page: 29 / 60

Installing the Board and Configuring the Device Driver
21
3
3
3
3
3
3
3
3
3
Inserting the DT3145 Board in the Computer
To insert the DT3145 board in the computer, perform the following
steps:
1. If necessary, discharge any static electricity by holding the
wrapped board in one hand while placing your other hand
firmly on a metal portion of the computer chassis.
2. If necessary, carefully remove the antistatic packing material
from the board. (It is recommended that you save the original
packing material in the unlikely event that your board requires
servicing in the future.)
3. Hold the board by its edges and do not touch any of the
components on the board.
4. Position the board so that the cable connectors are facing the rear
of the computer, as shown in
Figure 3 .
Figure 3: Inserting the DT3145 Board in the Computer
Rear of Computer
DT3145 Board
PCI Expansion Slot Bus Connector