Data Translation DT3130 Series, Getting Started Manual

Page: 40 / 54

Chapter 4
32
Connecting Trigger, Strobe, and Power
Signals to the Board
This section assumes that you have purchased an optional EP312
cable.
Connect trigger input and strobe output signals to connector J1 on the
DT3130 Series board by performing the following steps:
1. After making sure power to the computer is off, push the 15-pin
connector of one EP312 cable into the J1 socket at the rear of the
DT3130 Series, as shown in
Figure 7 , and tighten the screws on
the connector.
Figure 7: Connecting the EP312 Cable to Connector J1
J1
Trigger In 0+ 1
Trigger In 0
−
6
Trigger In 1+ 2
EP312
J2
+12 V 1
Trigger In 1
−
7
Strobe Out 0
+
5
Trigger In 2
+
3
Trigger In 2
−
8
Strobe Out 1
+
5
Strobe Out 1
−
4
Strobe Out 0
−
4
Strobe Out 2
+
5
Strobe Out 2
−
4
P3
+12 V Return 6
Strobe 0
Trigger
Strobe 1
Strobe 2
+12 V 4
+12 V Return 9
DT3130 Series
Board