PN 161-09993-000A
Oct 2006
FLC820G User’s Guide
Safety & Operational Notices
FCC Part 15 Notification
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received; including interference that
may cause undesired operation.
Federal Communications Commission (FCC) Statement
This Equipment has been tested and found to comply with the limits for a Class B and C digital device, pursuant to Part 15
of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in ac
-
cordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult Data-Linc Group or an experienced radio/TV technician for help.
RF Exposure
1.This Transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
2.This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equip-
ment should be installed and operated with a minimum distance of 23 centimeters between the radiator and your body.
Antenna / Coax / Amplifier Usage
While the use of amplifiers is authorized, only an approved amplifier may be used. The approved amplifier is:
•Teletronics SmartAmp 1W amplifier
The only external antennas approved for use are:
Without amplifier:
•12dbi (or less) Omni antenna
•14dbi (or less) Yagi antenna
•19dbi (or less) Panel antenna
1
•24dbi (or less) Parabolic grid antenna
1
With 1W amplifier
•8dbi (or less) Omni antenna (2db of coax loss is needed between the modem and antenna)
2
•10dbi (or less) Yagi antenna (4db of coax loss is needed between the modem and antenna)
2
1
Can only be used in a point-to-point application or with enough coax loss to keep the EIRP at the antenna 4W or
less per FCC rules
2
Needed to maintain 4W EIRP or less per FCC rules
Note:
Professional installation of this product, antennas and its antenna accessories is required.
