Data General 6662, Customer Documentation

Page: 10 / 24

Installing the Drive
4
014–002139
Unpacking and Inspecting the Drive
Follow the next steps to make sure your drive arrived undamaged and without missing
parts.
CAUTION: You can cause electrostatic discharge (ESD) damage to electronic
equipment by improper handling. For information about avoiding ESD
damage, refer to the section About This Manual."
1. Remove and set aside the packing slip from the outside of the shipping carton.
CAUTION: Handle your drive gently; do not drop or jar it. Make
sure you have a firm grip on it before you lift it, and lift it with both
hands.
2. Open the cartons one by one and remove the drive. As you do, carefully inspect
the drive for any visible damage. If the drive is damaged, contact Data General
as described in the section About This Manual."
3. Make sure that the model and part numbers on the drive match the drive model
and part numbers on your packing slip. If you think you received the wrong
drive, contact Data General as described in the section About This Manual."
4. Make sure that you received a 3Ć1/2 inchto 5Ć1/4 inchconversion bracket. If you
did not receive this bracket, contact Data General as described in the section
About This Manual."
Configuring the Model 6662 and 6796 Drive
This section explains how to set the jumpers on the Model 6662 and 6796 drives, and if
required, remove its terminator resistor pack. Figure 3 shows the location of the
jumpers and terminator resistor pack on the Model 6662 drive board layouts 1 and 2.
Figure 4 shows the location of the jumpers and terminator resistor pack on the Model
6796 (board layouts 1 and 2) drive board.