Data Domain DD400 Series, User Manual

Page: 70 / 300

Login and Configuration
32 DD400 Series Restorer User Guide
1. The first login to the restorer can be from a serial console, keyboard and monitor, through an
Ethernet connection, or through a web browser. Log in as user
sysadmin . The default password
is the serial number from the rear panel of the restorer. See Figure 17 for the location.
- From a serial console or keyboard and monitor, log in to the restorer at the login prompt.
- From a remote machine over an Ethernet connection, give the following command (with
the hostname you chose for the restorer) and then give the default password.
# ssh -l sysadmin host-name
sysadmin@host-name’s password:
- From a web browser, enter a path to the restorer. For example:
http://rstr01/
for a
restorer named rstr01 on a local network.
2. When using the command line interface, the first prompt after login gives the opportunity to
change the
sysadmin password. The prompt appears only once, at the first login to a new
system. You can change the sysadmin password immediately at the prompt or later with the
user change password
command.
To improve security, Data Domain recommends that you change the
'sysadmin' password before continuing with the system
configuration.
Change the 'sysadmin' password at this time? (yes|no) [yes]:
3. When using the command line interface, the restorer command
config setup
starts next.
4. The first configuration section is for licensing. Licenses that you ordered with the restorer are
already installed. At the first prompt, enter
yes to configure or view licenses.
- Enter the license characters, including dashes, for each license category.
- Make no entry and press Enter for categories that you have not licensed.
LICENSES Configuration
Configure LICENSES at this time (yes|no) [no]: yes
Figure 17: Serial number location
Serial number