Display User Manual
DDJ05996001
26-Mar-01
Page 4
2
Hardware
2.1
Unpacking
Carefully remove the items from their package and store the packaging safely. After unpacking,
inspect the contents for any damage that may have occurred during shipment. In the event of
damage, refer to the '
Technical Support'
section of this manual.
2.2
Installation
Each Display Board is supplied in two sections, Unit A and Unit B. The Power and Serial cables from
Unit A are not connected to the Terminal Blocks inside Unit B. Refer to Figure 1 for wiring
instructions. Mount the Board securely and connect the cables as shown in the Figure below.
Figure 2.1 – System Configuration
Graphic Board Display
128 x 48 Pixels
Unit A
Unit B
Control Box
Lens
Warning: Do NOT power up the Display
Board until all cabling is connected.
Power Consumption for Display: 2200W
INSTRUCTIONS
1.
Remove Side Profile of Unit B. Put all hardware in a safe place.
2.
Slide out Visor and Lens carefully.
3.
Remove 6 Display Panels on left-hand side of Unit B.
4.
Connect same color wires from Cables A and B to Terminal Blocks A and B in Unit B. Also connect Power, Serial,
Temp Signal and Common GND cables.
5.
Attach the 6 Display Panels.
6.
Slide in Lens and Visor.
7.
Butt the two Visor Plates together and attach the Visor Holding Plate
8.
Attach the Side Profile.
4
3
1
7
2
