Data Connect V.3600UI, User Manual

Page: 31 / 73

CHAPTER 3 : FRONT PANEL AND MENU TREE
3.5.3 PROTOCOL MENU
Item Name Command Description
Protocol Type AT\Nn
Select error correction and data compression function for async
mode only.
*This setting is ineffective in sync mode. It will automatically
become direct mode regardless of setting made once the link
established.
Normal AT\N0 /with DTE speed conversion only.Note that the flow control
function must be active.
Direct AT\N1 /disable error correction, data compression, and DTE speed
conversion.(modem speed=DTE speed)
Reliant MNP AT\N2 /Link con be established only when MNP function is enabled on
the remote modem.
Auto AT\N3 /Automatically negotiate V42/MNP level with the remote
modem. The negotiation sequence is V42bis-V42-MNP5-
MNP4-NORMAL.
Reliant LAPM AT\N4 /Link can be established only when V42 function is enabled on
the remote modem.
LAPM,Normal AT\N5 /Negotiate V42 level with the remote modem. The sequence is
V42bis-V42-NOMAL.
LAPM,MNP AT\N6 \/Automatically negotiate V42/MNP level with the remote
modem. The negotiation sequence is V42bis-V42-MNP5-
MNP4.
MNP Normal AT\N7 Negotiate MNP level with the remote modem. The sequence is
MNP5-MNP4-NORMAL.
Connect Code ATWn Select the extended CONNECT result code.
DTE Speed ATW0 /with DTE speed
DTE/EC/DCE ATW1 /with CARRIER, PROTOCOL, and DTE speed
DCE Speed ATW2 /with DCE speed
Discon. method ATS28=n Disconnect method for V34/V32bis/V32
Immediate (bit3,2) /Disconnect immediately.
With clear-down /Send clear-down sequence before disconnection (default)
Modem reset /Reset modem after disconnection
Login Check (this option is effective only under ANS mode). Assign the
password to authenticate dial-in modem:
Disable /Disable Login Check function.
#0..#9 /With this setting, ANS modem will authenticate dial-in modem
with one of the stored phone number #0..#9, timeout for waiting
password from dial-in modem is about 8 seconds; Control code
‘+’ can be applied in #0..#9.
(information about ‘+’ is described in section 4.17).
ALL /Authenticate dial-in modem with all stored phone number #0 to
#9. Any successful match will force ANS modem to grant the
access, timeout for waiting password from dial-in modem is
about 8 seconds; Control come ‘+’ can be applied in #0..#9.
By NMS /If ANS modem is a card type model
V3600Ui
, the
received password will be relayed to CS V1.5x for
authentication. Timeout for waiting password from dial-in
modem is about 8 seconds. If ANS mdoem is a standalone
model, this option will be the same as ‘ALL’. (The
program CS V1.5x is an additional software on CS server)
Send Password (this option is effective only under ORG mode). Assign the
stored telephone number, which will be sent out as password
during dial-out connection:
Off /Disable the action of sending password, this also disables the
function of Dynamic Password assignment function.
#0..#9 /Send one of the stored phone number between #0..#9 as the
26