using your dash shaved ice maker ∙ 9
8 ∙ setting up your dash shaved ice maker
SETTING UP YOUR DASh shaved ice maker
USING YOUR DASh shaved ice maker
Place the Base on a stable and dry surface.
Install the Motor Unit on the Base.
Align and insert the Exterior Bowl onto the assembled Motor Unit and
Base. The two notches on the side of the Exterior Bowl should fit into the
two notches on the inside of the Motor Unit.
Lastly, plug in the Power Cord.
1
2
3
NOTE:
You may want to clean your Dash Shaved Ice Maker before first using. If so, refer to
pages 10-14 for instructions and details.
Place ice cubes inside the Interior Bowl. The bowl should be filled to the
top level. If the ice has been in the freezer for a long time, it may be too
hard and may need to rest at room temperature for a few minutes before
shaving. The machine will then produce a fluffier snow.
Place the Clear Lid on top of the Interior Bowl, locking it into place by
aligning the fin-shaped notch on the lid with the corresponding notch on
the Motor Unit.
To activate the machine, turn the lid counter clockwise until the fin-
shaped notch activates the Safety Switch. To stop the shaving process,
turn the lid clockwise to deactivate the Safety Switch. For optimal results,
hold onto the lid during the shaving process to ensure all ice is shaved.
Unplug the Dash Shaved Ice Maker after each use.
1
2
4
Place an empty bowl on the base of the unit. This bowl will be used to
collect the shaved ice.
NOTE:
At this time you may want to insert the Ice Guard, which helps the ice shavings go
more directly into the bowl. Simply slide the Ice Guard into place so that the notches on the
Ice Guard and the Exterior Bowl align. (See red arrows on the left for reference)
3
