11
REAR PANEL (cont'd)
V
LR
MALE
QPEAK
ON
NL2
&
NL4
LINE INPUTS AND OUTPUTS
The inputs are made via 3-pin XLR connectors,
which are electronically balanced and should be
connected via a high grade twin core screened
cable, as follows:
Pin 1: Screen (see note below)
Pin 2: Hot ()
Pin 3: Cold (signal -)
The amplifier is designed to operate with fully balanced equipment and ground loops or loss
of performance may be experienced if connected to unbalanced sources. If it is unavoidable
however, the following wiring should be used. The cable should still be twin core plus screen.
Pin 1: Screen - connected to the chassis of the unbalanced equipment - or left disconnected
at the unbalanced end.
Pin 2: Hot ()
Pin 3: Cold (ground 0V)
NOTE: This amplifier is wired to the latest industry recommendations. Pin 1 is connected
directly to the chassis/mains earth. If ground loops (mains hum) are encountered remove
the screen connection from the other end of the cable and leave it open circuit. If problems
persist, consult your dealer/supplier.
DO NOT TAMPER WITH OR ALTER ANY GROUND (EARTH) CONNECTIONS INSIDE THE
AMPLIFIER.
For bridged operation input should be made to channel A (or C) only and the channels set
for bridged mode for the appropriate pair of channels.
SPEAKER OUTPUTS
The speaker outputs are via Neutrik Speakon connectors. 2 pole (NL2FC) or 4 pole (NL4FC)
connectors can be used.
Pin 1+: Hot
Pin 1-: Cold
Additionally, Channel 1 Speakon connector carries Channel 2 output on Pins +2 & -2 to allow easy
bi-amping or bridged operation using a single NL4 connector. Similarly, Channel 3's Speakon
connector also carries Channel 4 output.
Output Connector 1
Pin 2+: Hot Ch. 2
Pin 2-: Cold Ch. 2
Output Connector 3
Pin 2+: Hot Ch. 4
Pin 2-: Cold Ch. 4
E11EVEN SOUND \
DX
\
User’s Manual
Summary of Contents for SOUND E11EVEN DX Series
Page 16: ...www 11sound com ...
