4
3. ASSEMBLE OF THE EW-EN100 CONNECTOR ON THE DROPPER SEAT POST CABLE
The EW-EN100 is a connector with simple operation / display functionality.
3.1 Determine the place of the EW-EN100 asseble, then set up the adapter
3.2 Set up the EW-EN100 part, then connect it to the electric cables
The redundance of electric cable should be tucked into the frame. Then secure the electric cable on both sides of
the connector by wrapping the spiral provided in the kit. Cut the wrapper to adjust to the desirable length. The final
effect is shown in the photo on the left.
1.
Open the adapter and set the dropper seat post on
the cable.
2.
Bend the adapter on the dropper seat post cable.
Adapter
Cable housing
EW-EN100
Adjust the holes on the inside area.
CAUTION:
Installation of the EW-EN100
Install the EW-EN100 as shown in the figure below to aviod touching the sides of the frame. Otherwise, it
may be damaged in case of tipping over the bicycle and being squeezed between the frame and the ground.
Summary of Contents for E-THUNDERBIRD CF 2022
Page 5: ...5 TABLE OF CONTENTS...
