Darkly Labs Emblaser Core, User Manual

Page: 25 / 49

PAGE 21
USER MANUAL
Darkly Labs
Understanding the Laser Modes
The Emblaser can have its laser in one of three different ‘modes’.
Mode: Disabled
The laser will always default to ‘disabled’ mode
when first turned on.
This mode is indicated by the Laser LED being off.
In this mode, the machine will move as normal, but
the laser will not power up.
LASER POWER
Mode: Enabled
In ‘enabled’ mode, the laser will power up as requested by the software.
This mode is indicated by the Laser LED being on.
To enter ‘enabled’ mode:
1:
Depress the laser button for 2 seconds until
the red Laser LED blinks once.
LASER POWER
2:
Then release the laser button.
The red Laser LED will remain on.
LASER POWER
Mode: Focus
This mode becomes active when the Laser Guard is
removed.
Pressing and holding down the Laser button will
allow the laser to power up at a low level for
focusing.
Releasing the Laser button will immediately turn off
the laser.
LASER POWER
For more information about Laser Modes, see Appendix ‘Laser Modes’.