Microtubes B3K
CMOS Bass Overdrive
Little dude, Big attitude
You have acquired an unusual tool. A perfect combination of brutality
and clarity, the Microtubes B3K delivers defined and powerful
saturation in an intuitive format. There are no rules and no limits, so
dig in and unleash your tone.
Warning
The Microtubes B3K has a current draw of 20mA. Only use a
regulated 9V DC adapter with a center-negative plug. Due to
ecological reasons it does not accept batteries. Unregulated power
supplies and/or higher voltages may result in suboptimal noise
performance and even damage your unit, voiding the warranty.
Warranty
To activate the warranty, we encourage you to register your product
on: http://mypedal.darkglass.com and enter the serial number on
the back of your pedal.
Please contact us via email [email protected] before
shipping a product to us.
Controls
BLEND
: Mixes the clean input signal with the overdriven signal. The
clean signal remains at unity gain while the volume of the overdriven
signal is set by the Level knob, allowing for fine control of the blend ratio.
LEVEL
: Sets the volume of the overdriven signal.
DRIVE
: Sets the amount of saturation in the overdriven signal.
GRUNT SWITCH
: Sets the amount of low frequency content to
saturate by selecting between three different bass boost levels
before the clipping stage.
ATTACK SWITCH
: Sets the amount of treble content to saturate: The
“Boost” setting emphasizes the treble content extra clarity and
presence. The “Flat” position leaves this register untouched while
the “Cut” position will reduce the amount of high frequencies being
saturated. This new addition helps to keep the treble portion of the
signal under control, specially useful when playing with new strings
and/or cabinets with tweeters!
Disclaimer
In the interest of continuous improvement, specifications are subject
to change without notice. If you have any questions, please don’t
hesitate to contact us at www.darkglass.com
The manufacturer claims that the above product fulfills the
requirements as set by EN55013, EN55020, EN60555-2, EN60555-3,
RoHS, WEEE.
