Controls (Front)
Level
: Sets the volume of the
overdriven signal.
Duality
: Mixes two discrete
fuzz circuits. Set it at
minimum for a pure gated
saw-tooth wave, or crank it up
for a tighter high gain fuzz.
Controls (Back)
Open the magnetic bottom lid
to access the controls.
Blend
: Mixes the clean input
signal with the overdriven
signal. The clean signal
remains at unity gain while
the volume of the overdriven
signal is set by the Level knob,
allowing for fine control of the
blend ratio.
Filter
: Controls the amount of
high frequency content in the
fuzz signal.
Technical Specifications
Input Impedance 1 MΩ
Output Impedance 100 kΩ
Current Consumption ~40 mA
Voltage 9V DC (Center Negative)
Dimensions
Width 50 mm (2 in)
Height 100 mm (4 in)
Depth 45 mm (1.75 in)
Weight 205 g (0.45 lb)
Warning
The Duality Fuzz has a current draw of 40 mA. Only
use a regulated 9V DC adapter with a
center-negative plug. Due to ecological reasons it
does not accept batteries. Unregulated power
supplies and/or higher voltages may result in
suboptimal noise performance and even damage
your unit, voiding the warranty.
Disclaimer
In the interest of continuous improvement,
specifications are subject to change without
notice. If you have any questions, please don’t
hesitate to contact us at www.darkglass.com The
manufacturer claims that the above product fulfills
the requirements as set by EN55013, EN55020,
EN60555-2, EN60555-3, RoHS, WEEE.
Duality Fuzz
Dual Fuzz Engine