δ
DARIMO
Carbon Fiber-Handmade in Spain Darimo IX2 Stem
δ
DARIMO
Llíria (València) Spain
[email protected] www.darimo.eu
1
Instruction Manual: Darimo IX2 Stem
Thank you for buying a Darimo product. We design from the very first steps to the
handcrafted laminates to exceed your expectations in our products.
It is very important to follow the installations instructions to ensure proper
operation of the product. Improper installation can cause damages and Will reduce
the safety of the components.
You will need a torque wrench to adjust the torque without exceeding the
recommendations. If you don’t feel qualified to install the stem, ask for a bike
professional to do it. In case of any doubt you can contact us, we will help you
without any problem
-Headtube installation:
Make sure that the Darimo Stem is good for your Bike and handlebar. The
handlebar must have a central diameter of 31.8mm and the fork head tube
28.6mm diameter. The minimum length of the head tube to install the stem is
43mm, lower lengths are dangerous, the stem will not have enough contact
surface.
Apply a thin layer of mounting paste in both components, you can slightly open the
stem clamps to insert it. You can use a wedge of soft material such as a wood
clothespin. Once the head tube is inserted, tighten with the corresponding
expander and top cover.
Finally, alternately tighten the screws to a maximum of
3,5 Nm.
Maximum torque
3,5 Nm
Maximum torque
3,5 Nm
Minimum head
tube length
43mm
