Index
VXI-SC-1102 User Manual
I -2
©
National Instruments Corporation
filter specifications, A-2 to A-3
floating signal connection referenced to
chassis ground (figure), 3-6
front connector pin assignments (figure), 3-2
FTP support, B-1
G
gain and offset calibration, 5-2 to 5-4
Gain Register, 4-2
ground-referencing signals, 3-4
floating signal connection referenced to
chassis ground (figure), 3-6
ground-referenced signal connection
(figure), 3-5
H
hardware installation.
See
installation.
I
input damage level, exceeding (warning), 3-4
installation, 2-1 to 2-4
current-loop receivers, 2-3
hardware installation, 2-4
parts locator diagram, 2-2
unpacking the VXI-SC-1102, 1-6
L
LabVIEW application software, 1-3
LabWindows/CVI application software, 1-4
M
manual.
See
documentation.
Module ID Register, 4-2
N
NI-DAQ driver software, 1-4 to 1-5
P
parts locator diagram, 2-2
physical specifications, A-3
pins
front connector pin assignments
(figure), 3-2
front connector signal descriptions
(table), 3-3
power requirements, A-3
R
requirements for getting started, 1-3
resistors
bent and trimmed resistor (figure), 2-3
disconnecting signals before installing
(warning), 2-3
installing current-loop receivers, 2-3
S
scan interval, minimum, 4-3
settling time (note), 4-3
signal connections, 3-1 to 3-6
channel input signal connections,
3-3 to 3-4
cold-junction sensor connection, 3-6
front connector pin assignments
(figure), 3-2
ground-referencing signals, 3-4
floating signal connection referenced
to chassis ground (figure), 3-6
ground-referenced signal connection
(figure), 3-5
signal descriptions (table), 3-3
static electricity damage (caution), 3-1
signal terminals for input channels, 3-3
software programming choices, 1-3 to 1-5
National Instruments application
software, 1-3 to 1-4
NI-DAQ driver software, 1-4 to 1-5
Summary of Contents for VXI-SC-1000
Page 1: ...VXI SC 1000...
