NET-AIO11 User’s Manual (Rev 1.0)
-
5-
http://www.daqsystem.com
3.
Hardware Device
In this chapter, board jumper set and connector for interfaced the PC or other operation
equipment is described.
USB-B
Connector
LED
(PWR,RUN)
POWER
Connector
Ethernet
Connector
AIN
Connector
DSP Mode
Setup Jumper
Reset Switch
[Figure 2. Connector, Switch Placement]
3.1
DSP Mode Setup Jumper (J2)
The execution mode of the board is the USB boot mode and flash boot mode. The Flash
boot mode (jumper OFF) is the general board operation. On the other hand, the USB boot
mode is used when frequent firmware updates or develops flash memory program.
3.2
USB-B Connector (CN1)
It is a B-type USB connector. It is connected to a PC and is done a data transmission.
3.3
LED(PWR, RUN) (D22)
The power and status of board is displayed. When connecting the power, the red led
light on. When collecting the data, the green led light on.
