12
WMS6-W
Product code: D3841
Drilling Mounting Holes
01)
Hold the mounting plate (07) against the wall, as shown in Fig. 07, and mark the mounting locations.
Fig. 07
02)
Drill holes at the marked locations. See 4.3.1.1. Drilling into Wood or 4.3.1.2. Drilling into Concrete on
page 12 for more information.
03)
Insert anchors into the drilled holes (Fig. 08). Do not perform this step when mounting the device on a
wooden wall.
Fig. 08
Drilling into Wood
If you drill into wood, use hardwood drill bits. Predrill before inserting screws, to remove drill dust and to
avoid damaging of the wood.
Fig. 09
Note:
Hardwood drill bits shall be of the diameter slightly smaller than the screws used (e.g. for Ø 5 mm screws,
use a Ø 3,5 mm hardwood drill bit).
Drilling into Concrete
If you drill into a concrete wall, use drill bits for concrete. Do not drill into mortar joints. Screws installed in
mortar joints cannot safely support the weight of the device.
Fig. 10
Notes:
Drill bits shall be of the same diameter as the anchors.
Summary of Contents for WMS6-W
Page 11: ...10 WMS6 W Product code D3841 Dimensions Fig 06 ...
Page 22: ...21 WMS6 W Product code D3841 ...
Page 23: ...22 WMS6 W Product code D3841 ...
Page 24: ... 2022 DAP ...
