6
Set Up and Operation
Soundmate Easy is a 2 way active satellitesystem with one 10” 300 watt sub-woofer and two 6,5” 75 Watt
mid/high units.
The set comes complete with stands and 2 Speakon cables and is ready to use. The amplifier-section is
build into the subwoofer and consists of 3 separate power-amplifiers. Further built-in are the crossovers,
frequency response correction circuits, breaker circuitry.
The SoundMate system can be used for small live gigs, events and less Mobile DJ’s.
It’s easy to set up; All you have to do is set up the system components, connect the signal-carrying cables
and power cords and you're ready to roll.
Follow the directions below, as they pertain to your preferred operation mode.
Signal Input (10)
This XLR sockets serve as inputs for the audio signal. There are also 2 parallel outputs for connecting
additional power amps.
Speaker Output (13)
It is not possible to connect additional tops to the Speakon socket. You can only connect the 2 speakers via
the 2 Speakon sockets
Make sure that the impedance is not below 4
, otherwise the power amp could be damaged.
Mains Socket (14)
Plug one end of the electric mains power cord into the IEC socket on the unit.
Then plug the other end of the cord into a proper electric power supply socket.
Make sure that the available voltage is not higher than stated on the rear panel.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa
Mains Switch (16)
Do not supply power before the whole system is set up and connected properly.
