7
Below you will find a short description of the features from the SoundMate 3 :
Satellite / fullrange switch (1)
This switch allows you to use the Soundmate 3 topcabinet in 2 different modes. Either as a topcabinet for
use in small venues or rehearsel rooms, or in combination with the Soundmate 3 bass cabinets for more
powerfull sound.
If you choose to operate the top without subwoofers, set the SATELLITE / FULLRANGE
switch to "Full-range", so that the entire frequency range including the bass frequencies
will be produced by the satellite.
Set the SATELLITE / FULLRANGE
switch to Satellite. The Subwoofer from the
Soundmate system amplifies the low-end frequencies in standard set-up.
All frequencies below 120Hz will be filtered out in the satellite.
Ground Lift (2+9)
When this button is pressed, it separates the signal ground from the chassis ground, enabling you to
eliminate potential ground loops or low-frequency hum.
Through (3+10)
This parallel output allows you to connect more satellites or bass-cabinets together as well to connect other
systems such as monitor power amplifiers, individual components etc.
Input (4+11)
The input equipped with 3 pole XLR chassis connector is electronically balanced to accept the (line) signal
from any mixing console.
Volume / Gain (5+12)
This allows you to adjust the audio level.
Mains Socket (6+13)
Plug one end of the electric mains power cord into the IEC socket on the unit.
Then plug the other end of the cord into a proper electric power supply socket.
Make sure that the available voltage is not higher than stated on the rear panel.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa
Mains Switch (7+14)
Do not supply power before the whole system is set up and connected properly.
Fuse (8+15)
An external fuse protects your system for any damage caused by electrical faillures.
