12
Installation
Remove all packing materials from the Set Mixer. Check that all foam and plastic padding is removed.
Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage.
Install this device on a flat surface, not bending or curved.
Do not supply power before
all components of the system are
set up and connected properly.
Study this setup diagram. Make sure all faders are at "zero" and all devices are off. First, connect all input
sources and processors. Next, connect your microphone and monitor headphones. Finally, connect the
stereo outputs to the power amplifier(s) and/or audio receivers such as tape decks. Plug your mixer into
AC power. Now you are ready to switch everything on.
IMPORTANT:
Always switch on your audio input sources such as turntables or CD players first, then your
mixer, and finally any amplifiers. When turning off, always reverse this operation by turning off amplifiers,
then your mixer, and then input devices.
TURNTABLE
TURNTABLE
SOUND SYSTEM
TAPE DECK
CD PLAYER
POWER
SUPPLY
Fig. 6
Summary of Contents for Quick Start Guide
Page 1: ...DJ SET ORDERCODE D1210...
Page 18: ...2003 DapAudio...
