DAPAudio PA-805CDTU, User Manual

Page: 11 / 20

10
47. Tel. Paging level
Use to adjust the input volume level for the telephone paging (49) input terminals.
48. 1W/8Ω Monitor output terminals
Use these terminals to connect an 8Ω monitor speaker.
49. Telephone paging input terminals
Use these terminals to connect a telephone system equipped with a paging port.
50. 8
Ω
terminal
Connect this terminal to the + terminal of your 8
Ω
speaker(s).
In case of using several speakers, make sure that the total speaker load is 8
Ω
. The total power rating of
the low impedance speakers connected to this terminal summed, should be at least 80W.
51.
Priority remote terminal
Use this terminal for connecting a remote switch or relay contact. Closing this contact will mute all inputs
except input 1.
52. FM Antenna connector
Connect your FM antenna to this connector
53. AC-selector
Before connecting your PA-805CDTU to the mains, make sure the AC-selector is set to the proper voltage
used in your country. If you’re not sure, consult a skilled technician.
54. AC Inlet with integrated fuse holder
This connector is meant for the connection of the supplied main cord. Connect one end of the power
cord to the connector, the other end to the mains, then turn on the
power (11) switch to operate the
unit.
Make sure that the supply voltage matches the operation voltage before connecting the unit to mains.
Replace the fuse only with a fuse of the same specification (230V:T1,6A, 115V:T3,5A).
55. Combo input 2
Combo input for channel 2. Accepts balanced or unbalanced inputs.
56. Combo input 3
Combo input for channel 3. Accepts balanced or unbalanced inputs.
57. Combo input 4
Combo input for channel 4. Accepts balanced or unbalanced inputs.
58.
Input 5
RCA stereo input for connecting a line level device such as an I-pod, CD player etc.
59. Rec out output
Use this output to connect a recording device.
60. DC 24V/8A terminal
DC 24V input (battery)
61. Common speaker terminal
Connect this terminal with the – terminal of your low speaker(s).
62. 4
Ω
terminal
Connect this terminal to the + terminal of your 4
Ω
speaker(s).
In case of using several speakers, make sure that the total speaker load is 4
Ω
. The total power rating of
the low impedance speakers connected to this terminal summed, should be at least 80W.