DAPAudio MPXA-80, Instructions Manual

Page: 8 / 20

6
12. Tuner
See page 8.
13. AC Power Switch
This is the main Power switch. Press to turn the amplifier on.
Backpanel
Fig. 2
14. AC-selector
Before connecting your MPXA-80 to the mains, make sure the AC-selector is set to the proper voltage
used in your country. If you’re not sure, consult a skilled technician.
15. Priority remote terminal
Use this terminal for connecting a remote switch or relay contact. Closing this contact will mute all
inputs except input 1. If the chime button (10) is pressed, a chime signal will be put out.
16. DC power
17.
Siren remote terminal
Use this terminal for connecting a remote switch or relay contact. Closing the switch will activate the
siren, independent of the siren front switch (11).
18. Input 1 priority terminal
Bridge the 2 terminal contact with a wire to disable the input 1 voice priority/ VOX function.
21. Telephone terminal
Use this terminal to connect a telephone set for broadcasting emergency messages.
23. Power amp in/ Pre amp out
Mono RCA in/ out. Use this input if You want to use an external preamp or power amplifier.
26. Combo input 3
Combo input for channel 3. Accepts balanced or unbalanced inputs.
27. Combo input 2
Combo input for channel 2. Accepts balanced or unbalanced inputs.
28. Combo input 1
Combo input for channel 1. Accepts balanced or unbalanced inputs.
29. AC Inlet with integrated fuse holder
This connector is meant for the connection of the supplied main cord. Connect one end of the
power cord to the connector, the other end to the mains, then turn on the power switch (13) to
operate the unit.
Note: Please make sure that the supply voltage matches the operation voltage before connecting
the unit to mains.
Replace the fuse only with a fuse of same specification (230V:T1.5A/ 115V: 3A).
30. DC 24V terminal
DC 24V input (battery)
31. Common speaker terminal
Connect this terminal with the – terminal of your low speaker(s).
32. 4
Ω
terminal
Connect this terminal to the + terminal of your 4
Ω
speaker(s). In case of using several speakers make
sure that the total speaker load is 4
Ω
. The total power rating for each channel of the low impedance
speakers should be at least 80W.