DAPAudio MPXA-180, Product Manual

Page: 8 / 12

6
Controlpanel
Fig. 2
1) Bass
Use to adjust the Bass frequencies to your preference.
2) Treble
Use to adjust the treble frequencies to your preference.
3) Overload LED
4) Volume
Use to adjust the volume level for each channel to your preference.
5) Combo Input
6) MIC/ LINE- Button
Allows you to set the input impedance/ sensitivity to either Line or Microphone level (Line =
on, microphone = off).
7) Link XLR Output
8) AC Power Switch
This is the main Power switch. Press to turn the PS-112A on.
9) Power LED
Indicates that the unit is on.
10) AC Inlet with integrated fuse holder
This connector is meant for the connection of the supplied main cord. Connect one end of the
power cord to the connector, the other end to the mains, then turn on the power switch (13) to
operate the unit.
Note: Please make sure that the supply voltage matches the operation voltage before connecting
the unit to mains.
Replace the fuse only with a fuse of same specification (F8A).
Operation
Installation
Remove all packing materials from the PS-112A. Check that all foam and plastic padding is removed.
Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 240V power, or vice versa.
Do not supply power before all components of the system are set up and connected properly.