9
Maintenance
The
DAP Audio EB-16
requires almost no maintenance. However, you should keep the unit clean.
Disconnect the mains power supply, and then wipe the cover with a damp cloth. Do not immerse in
liquid. Do not use alcohol or solvents.
Keep connections clean. Disconnect electric power, and then wipe the DMX and audio connections
with a damp cloth. Make sure connections are thoroughly dry before linking equipment or supplying
electric power.
Troubleshooting
DAP Audio EB-16
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. Once the unit operates properly, do not carry out following
steps.
1.
If the device does not operate properly, set the switch on the beltpack in OFF position.
2.
Check the batteries, etc.
3.
If all of the above appears to be O.K., Set the switch in ON position.
4.
If you are unable to determine the cause of the problem, do not open the beltpack, as this may
damage the unit and the warranty will become void.
5.
Return the beltpack to your DAP Audio dealer.
Product Specification
Model: DAP Audio EB-16
Power: Battery 2x UM2, AA1.5V
Dimensions: 114 x 68 x 25 mm (LxWxH)
Weight: 1,08 Kg
Frequency Preparation: Crystal
Carrier Frequency Range: 600-960 MHz
RF Output: 10 mW
Stability: ±0.005%
Frequency Deviation: ±48 kHz
Controls: Power On/Off, AF gain
Spurious Rejection: < -60 dBC
Audio Freq. Response: 50Hz – 16kHz
Phantom Power: 5Vdc (pin 2)
Battery: UM3, AA 1.5V x 2
Design and product specifications are subject to change without prior notice.
