9
Fig.6
37. GND
Use to connect the ground wire of your turntable.
38. GND
Use to connect the ground wire of your turntable.
39.
AC Inlet
This connector is meant for the connection of the supplied main cord. Connect one end of the power
cord to the connector, the other end to the mains, then turn on the power switch to operate the unit.
Note:
Please make sure that the supply voltage matches the operation voltage before connecting
the unit to mains.
40. Master XLR Balanced Out
Use these outputs to connect an amplifier with balanced inputs.
41. Trim Output Control
Use this control to match your master out optimally to your amplifier.
Note:
If the control is turned completely to the left, there is no output signal.
42. Fader Start B
1/4” jack for remote fader start.
43. Fader Start A
1/4” jack for remote fader start.
44. Master RCA Unbalanced Out
Use these outputs to connect an amplifier with unbalanced inputs.
45. Zone RCA Unbalanced Out
Use these outputs to connect an amplifier with unbalanced inputs.
46. Record RCA Unbalanced Out
Use these to connect a recording device
.
47. Channel 3 Line 4 RCA Input
Use to connect a line level device.
48. Channel 3 Line 3 RCA Input
Use to connect a line level device.
49. Channel 2 Line 2 RCA Input
Use to connect a line level device.
50. Channel 2 Aux 2/ Phono 2 RCA Input
Use to connect either a phono or line level device depending on the position of the Channel 2
Aux 2/
PHONO 2
(51)
switch.
51. Channel 2 Aux 2/Phono 2 Selector
Used to set the input level for the
Aux 2/ Phono 2 (50)
Input to either phono or line level.
52. Channel 1 Line 1 RCA Input
Use to connect a line level device.
53. Channel 1 Aux 1/ Phono 1 RCA Input
Use to connect either a phono or line level device depending on the position of the Channel 1
Aux 1/Phono 1 (54)
selector.
54. Channel 1 Aux 1/Phono 1 Selector
Used to set the input level for the
Aux 1/ Phono 1 (53)
Input to either phono or line level.
55. Mic attenuator
This control can be used to attenuate the microphone channel’s input level.
56. MIC 2 Jack Unbalanced Input
MIC 2 channel ¼” unbalanced microphone input.
Summary of Contents for DS-CM-10
Page 1: ...DS CM 10 ORDERCODE D2183...
Page 17: ...2009 DapAudio...
