17
DRX Active Series
Model
DRX-15A
System
2-Way Active Vented Speaker Cabinet
Continuous power
LOW: 220W / HIGH:30 W
Total harmonic distortion
LOW-input/-3dBu 100Hz, out load 4 Ohms , THD
＜
0.5%
HI-input/-3dBu 15KHz, out load 8Ohms, THD
＜
0.5%
S/N Ratio
LOW:
＞
80dBu / HI:
＞
70dBu
Line input Level
-5dBu ± 1dBu
Input Impedance
Line 15KΩ input
Indicator
Power ,Clip,Signal
Power supply
115 V 60 Hz / 230 V 50 Hz Switchable
External controls
Volume Control / Power ON with Green LED / Clip Limiter
with Red LED/Ground Lift.
SPL@1m
96.5 dB / 123.5 dB (Max.)
Frequency Response
50Hz - 20kHz - 6dB
Woofer
15" Ø 381mm - 2" Voice Coil
Driver
1" Driver - 1" Voice Coil
Horn Coverage (H*V)
50° x 50°
Enclosure Construction
15mm plywood cabinet, glued and reinforced, resistant
black paint; metal grille, rubber foot.
Mounting
One ABS plastic standard pole-mount
Dimensions (H x W x D)
522 x 486 x 736mm
Troubleshooting
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. Once the unit operates properly, do not carry out following
steps.
1. If the device does not operate properly, unplug the device.
2. Check the fuse, power from the wall, all cables, etc.
3. If all of the above appears to be O.K., plug the unit in again.
4. If you are unable to determine the cause of the problem, do not open the device, as this may
damage the unit and the warranty will become void.
5. Return the device to your Dap Audio dealer.
