DAPAudio D6161, Manual

Page: 8 / 16

PA-500
Ordercode: D6161
Fig. 03
100V terminal input connector
Connect the main feed cable from your 100V signal source to the 100V terminal. Connect the
common cable to the 0 terminal.
Volume control
Turn the control to adjust volume.
Installation
Remove all packing materials from the PA-500. Check if all foam and plastic padding is removed. Secure
the equipment into a 19" rack if preferred. Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 115V specification product on 230V power, or vice versa.
Before powering up the first time, make sure that the AC selector is set to the proper
voltage!
Damage caused by connecting the amplifier to improper AC voltage is not covered
by any warranty!
Always turn off and disconnect the amplifier from mains voltage before making audio
connections. The attenuators should always be turned down during power-up.
Connecting Inputs
Use the XLR input connector on the rear to supply audio signals to your DAP Audio PA-500 amplifier. The
RCA connectors accept unbalanced audio connections while the XLR connector accepts balanced
audio connections.
7