6
Installation
Remove all packing materials from the Cesium. Check that all foam and plastic padding is removed.
Screw the equipment into a 19" rack. Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 240V power, or vice versa.
Install this device on a flat surface, not bending or curved.
Do not supply power before
all components of the system are
set up and connected properly.
You can connect the Cesium in 2 different modes: Stereo and Parallel
CONNECTING FOR CESIUM 200 and 300 :
Stereo mode:
In this mode, connect the 2 inputs CH1 and CH2 to your mixer's outputs.
Put the selector to the stereo position.
Output volume can be adjusted by means of the two potentiometers.
Connect the 2 turn lock outputs to the 2 speakers.
Parallel mode:
In this mode, connect the input CH1 to your mixer's outputs.
Put the selector on the parallel position.
Outputs volume can be adjusted by means of the two potentiometers.
Connect the 2 turn lock outputs to the 2 speakers.
