DAPAudio CA-2300, Operating Instructions Manual

Page: 11 / 16

10
Ordercode: D4513
CA-2300
Troubleshooting
CA-2300
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. If the unit operates properly, do not carry out following steps.
01) If the device does not operate properly, unplug the device.
02) Check power from the wall, all cables, connections, etc.
03) Replace the fuse. See page 9 for more information.
04) If all appears to be O.K., plug the unit in again.
05) If nothing happens after 30 seconds, unplug the device.
06) Return the device to your DAP Audio dealer.
Product Specifications
Output Power
 Stereo 2Ohm: 2 x 450W RMS
 Stereo 4Ohm: 2 x 300W RMS
 Stereo 8Ohm: 2 x 200W RMS
 Bridge 2Ohm: Not allowed
 Bridge 4Ohm: 1 x 400W RMS
 Bridge 8Ohm: 1 x 300W RMS
 Frequency response: 20Hz – 20kHz, +0/-1dB
 THD: <0.1%
 S/N rate: >98dB A-weighted
 Crosstalk: >70dB
 Damping factor: >180
 Gain: 30V
 Input sensitivity: 0,9-1,1V (+/-1dBv)
 Input impedance: 20kOhm balanced, 10kOhm unbalanced
 Output mode: Stereo, Bridge
 Amp technology: Class D
 Power supply: SMPS
 Protection: Clip Limiter (Fixed) Short Circuit
Overheat
Overload
DC Voltage
Soft Start
 Cooling: Forced-air by radial fan
 Air flow: Front to back
 Installation depth: 278 mm (excl. conn.)
 Input connectors: 3-pin XLR IN, TRS 6,3 mm Jack IN
 Output connectors: Speakon OUT, TRS 6,3 mm Jack OUT
 Power connector: IEC
 Input voltage: 210-240V AC, 50/60Hz
 Power consumption: 750W
 Fuse: T5AL/250V
 Dimensions: 483 x 281 x 44 mm (LxWxH)
19” x 1HE
 Weight: 4,2 kg
Design and product specifications are subject to change without prior notice.
Website: www.Dap-audio.info
Email: service@highlite.nl