8
ACX-2
Ordercode: D1905
Mono-Stereo switch
With this switch you can activate the Mono mode or Stereo mode.
Channel 2 output low (jack 6,3 mm)
Balanced stereo 6,3 mm jack output for the Low frequency band in stereo mode. In the mono mode
this is a mono 6,3 mm jack output for the Middle frequency band.
Channel 2 output low (XLR)
Balanced stereo XLR output for the Low frequency band in stereo mode. In the mono mode this is a
mono XLR output for the Middle frequency band.
Channel 2 output high (jack 6,3 mm)
Balanced stereo 6,3 mm jack output for the High frequency band in stereo mode. In the mono mode
this is a mono 6,3 mm jack output for the High frequency band.
Channel 1 output high (XLR)
Balanced stereo XLR output for the High frequency band in stereo mode. In the mono mode this is a
mono XLR output for the High frequency band.
IEC power connector 230V AC + Fuse T100 mAL/250V
Connect the device to the appropriate power supply.
Installation
Remove all packing materials from the ACX-2. Check if all foam and plastic padding is removed. Secure
the equipment into a 19" rack if preferred. Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 115V specification product on 230V power, or vice versa.
Summary of Contents for ACX-2
Page 15: ...14 ACX 2 Ordercode D1905 Dimensions...
Page 16: ...2016 DAP Audio...
